Troubleshooting
41
PROBLEM
CORRECTIVE ACTION
POSSIBLE CAUSES
Excessive black smoke from
exhaust.
1.
The air cleaner element is
dirty.
1.
Clean or replace.
2.
The injection pump timing is
incorrect.
2.
Contact your Authorized
Service Dealer
.
3.
Incorrect fuel is in the fuel
system.
3.
Drain the fuel system and
refill with specified fuel.
4.
The injection nozzles are
damaged.
4.
Contact your Authorized
Service Dealer
.
5.
The injection pump is
damaged.
5.
Contact your Authorized
Service Dealer
.
6.
Excessive loading.
6.
Reduce load; use lower
ground speed.
Excessive white smoke from
exhaust.
1.
The key was turned to the
start position before the glow
plug light turned of
f.
2.
The engine temperature is
low.
3.
The glow plugs are
inoperative.
4.
The fuel injection nozzles are
damaged.
5.
The injection pump timing is
incorrect.
6.
Low compression.
1. T
urn the key to the run
position and allow the glow
plug light to turn of
f before
starting the engine.
2.
Check the thermostat.
3.
Check the fuse, glow plugs
and wiring.
4.
Contact your Authorized
Service Dealer
.
5.
Contact your Authorized
Service Dealer
.
6.
Contact your Authorized
Service Dealer
.
T
raction unit does not drive.
1. T
raction pump drive coupler
is loose or broken.
1.
Contact Authorized Service
Dealer.
2.
Hydro fluid level low
.
3.
Pump and/or wheel motor is
damaged.
4.
Control valve is damaged.
5.
Relief valve is damaged.
6.
Flow divider valve lever is in
9 o’clock position.
2.
Add hydro fluid to reservoir
.
3.
Contact your Authorized
Service Dealer
.
4.
Contact your Authorized
Service Dealer
.
5.
Contact your Authorized
Service Dealer
.
6.
Move lever to 12 o’clock to
10 o’clock position.
To Next Page
Loading...
