Toro 22615 - Grinding a Stump

GrindingaStump
DANGER
Thismachineiscapableofamputatinghands
andfeet.
•Alwayswearsubstantial,slip-resistant
footwear.
•Stayintheoperatingpositionwhilethe
machineisrunning,andkeepawayfrom
movingparts.
•Keepallbystandersasafedistanceaway
fromthemachine.
•Stopthemachineimmediatelyifany
peopleoranimalsentertheworkarea.
WARNING
Grindingastumpthrowswoodchips,soil,
andotherdebrisintotheair,whichcould
injureyouorbystanders.
•Alwaysweareyeprotectionandlongpants
whenusingthegrinder.
•Keepallbystandersasafedistanceaway
fromthegrinder.
WARNING
Thegrinderisveryloudwhencuttingastump
andcandamageyourears.
Alwayswearhearingprotectionwhenusing
thegrinder.
1.SetthrottletotheDISENGAGEposition,startthe
engine,andallowthemachinetowarmupfor
2minutes.
2.Pushthehandledownenoughtoraisethe
cuttingwheelofftheground(Figure10).
g024063
Figure10
1.Pivotpoint2.Pivotpointwhenthe
parkingbrakeisengaged
3.Movethemachinetothefrontofthestumpand
engagetheparkingbrake.
4.MovethrottleuptotheENGAGEposition.The
cuttingwheelwillbeginrotating.
5.Swingthecuttingwheeltooneside(Figure10),
thenloweritapproximately1to2.5cm(1/2to1
inch)intothefront-topcornerofthestump.
g024062
Figure11
6.Usingasweepingmotion,swingthecutting
wheelbackandforth,loweringthecuttingwheel
approximately1to2.5cm(1/2to1inch)before
11