Toro 30393 - Mounting the Debris Blower to the Traction Unit; Adjusting the Link Assembly

3.Makesurethecastorwheelassemblytireisinatedto
35to50psi.
2
MountingtheDebrisBlowerto
theTractionUnit
Partsneededforthisprocedure:
1Debrisblowerassembly
1Lockingpin
1Hairpincotter
Procedure
1.Removeanyattachmentfromtherearofthemachine.
2.Backthetractionunitintopositionbehindthe
attachmentadapter.
Note:Makesurethelockinglever(Figure4)ispivoted
totheleft(unlockedposition)asviewedfromtherear
ofthemachine.
G003810
1
2
Figure4
1.Attachmentadapter2.Lockinglever
3.Raisethetractionunitadapterintotheattachment
adapter.
4.Pivotthelockinglevertotherighttolocktheadapters
together.
5.Insertthelockingpinthroughtheadaptersandsecure
withahairpincotter(Figure5).
1
G006618
Figure5
1.Lockingpin
6.Routethehosesthroughthehosesupportloop.
7.Removethedustplugsfromthehydrauliccouplers
andmakesurethatthecouplersarefreeofanydirtor
contamination.
8.Connecttheattachmenthydraulichosecouplerstothe
hydrauliccouplersonthetractionunitrearauxiliary
hydraulicpowerkit.
Important:Wheneverthehydraulichosecouplers
aredisconnected,makesurethatthedustplugs
areinstalledtopreventcontaminationfrom
enteringeitherhydraulicsystem.
3
AdjustingtheLinkAssembly
NoPartsRequired
Procedure
1.Withthedebrisblowermountedandsecuredonthe
tractionunit,raisetheattachment.
2.Measurethegapbetweenthetopwasherandthe
spacerinthelinkassemblyontheattachmentadapter
asshowninFigure6.
Note:Thegapbetweenthewasherandtheshoulder
shouldbe1.5to2.0mm(0.060to0.080inch).
7