Toro 30449 - Operator Cab Fuses (Groundsmaster 4110-D)

Groundsmaster 4100--D/4110--DPage 5 -- 22Electrical System
Operator Cab Fuses (Groundsmaster 4110--D)
The cab fuse blocks are located in the cab headliner
(Fig. 19).
Identification and Function (Figs. 19 and 21)
Fuse F1--1 (20 Amp) protects the air conditioner circuit.
Fuse F1--2 (20 Amp) protects the cab lighting circuit.
FuseF1--3(20Amp)protectsthecabfananddomelight
circuits.
Fuse F2--1 (20 Amp) protects the heater circuit.
Fuse F2--3 (20 Amp) protects the windshield wiper/
washer circuit.
Fuses F1--4, F2--2 and F2 --4 are available for optional
cab equipment (work lights and rear window wiper).
Testing
Turn ignition switch to the ON position (do not start en-
gine). With the fuse installed in the fuse block, use a
multimetertoverifythat12VDCexistsatboth oftheter-
minal test points on the fuse. If 12 VDC exists at one of
thefusetestpointsbutnotattheother,thefuseisfaulty.
If necessary, make sure that ignition switch is OFF and
key is removed from switch. R emove fuse from fuse
blockandcheckthatfusehascontinuityacrossthefuse
terminals.
Figure 19
1. Cab fuse blocks
1
Figure 20
Figure 21
1234
20A
F1
F2
20A
20A
20A
20A