Toro 38472 - Setup; Installing the Handle; Installing the Recoil-Starter Handle

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Oval-headbolts
2
Curvedwashers
2
1
Handleknobs2
Installthehandle.
2
Nopartsrequired
–
Installtherecoilstarterhandle.
Dischargechute1
Screws
2
Washers2
Locknuts2
3
Knob1
Installthedischargechute.
4
Bottleofengineoil
1Filltheenginewithoil.
5
Nopartsrequired
–
Adjustthecontrolcable.
1
InstallingtheHandle
Partsneededforthisprocedure:
2
Oval-headbolts
2
Curvedwashers
2Handleknobs
Procedure
1.Positiontheendsoftheupperhandleontheinsideof
thelowerhandleandaligntheholes.
2.Inserttheoval-headboltsintothealignedholes,with
theboltheadsontheoutsideofthehandle(Figure3).
Figure3
1.Oval-headbolt(2)2.Curvedwashersand
handleknobs
3.Installthecurvedwashersandthehandleknobsonthe
oval-headboltsontheinsideofthehandle(Figure3)
andtightentheknobssecurely.
Important:Ensurethatthecableisroutedtothe
outsideofthehandle.
4