Toro 38517 - Installing the Chute Crank; Installing the Discharge Chute

Figure 6
6. Tighten the knobs until they are sn ug .
7. Adjust the control cable . R efer to Adjusting the Control
Cable .
2. Installing the Discharge
Chute
Install the disc harg e c hute as sho wn ( Figure 7 ).
Figure 7
3. Installing the Chute Crank
1. Inser t the end of the c hute crank through the hole in
the shroud and align the mounting brac k et with the
holes in the lo w er handle ( Figure 8 ).
Figure 8
1. Chute crank 3. Mounting bracket
2. Hole in the shroud 4. Plastic bushing
2. Slo wly rotate the crank until the end of the c hute crank
fits into the hidden g ear opening and the disc harg e
c hute tur ns the crank.
Note: Ensure that the plastic bushing is fully inser ted
into the hole in the mounting brac k et ( Figure 8 ).
3. Secure the mounting brac k et to the handle with 2 bolts
and 2 loc kn uts .
7