Toro 38517 - Stopping the Engine; Starting the Engine; Starting the Rotor Blades; Filling the Fuel Tank

4. Shak e the container to mix the g asoline and oil
thoroughly .
5. Slo wly remo v e the cap and add the remaining amount
of g asoline .
Note: Do not mix g asoline and oil in the fuel tank. Oil
at room temperature mix es easier and more thoroughly
than cold oil. Oil belo w 32°F (0°C) requires additional
mixing
Filling the Fuel Tank
Fill the fuel tank with a fresh mixture of g asoline and oil
mix ed at the proper ratio ( Figure 12 ).
Figure 12
Starting the Engine
1. T ur n the ignition k ey cloc kwise to the On position
( Figure 13 ).
Figure 13
2. Mo v e the c hok e lev er to the right ( Figure 14 ).
Figure 14
3. Fir mly push in the primer 2 times with y our thumb ,
holding the primer in for a second before releasing it
eac h time ( Figure 15 ).
Figure 15
4. Pull the recoil star ter ( Figure 16 ).
Figure 16
5. With the engine r unning, mo v e the c hok e lev er to the
left slo wly .
Stopping the Engine
T o stop the engine , tur n the ignition k ey countercloc kwise
to the Off position ( Figure 17 ).
Figure 17
Starting the Rotor Blades
T o star t the rotor blades , hold the control bar ag ainst the
handle ( Figure 18 ).
Figure 18
9