Need help?Do you have a question about the Toro 5 and is the answer not in the manual?
Guidelines for safe operation of the cutting unit and traction unit.
Information on the location and importance of safety decals on the cutting unit.
List of parts shipped with the cutting unit for verification.
Procedures for inspecting the cutting unit after unboxing.
How to adjust the front shield for grass clippings dispersion.
Instructions for adjusting or opening the rear shield for grass dispersion.
Steps to adjust the turf compensation spring for weight transfer and attitude.
Procedure to ensure the bedknife is parallel to the reel for proper cutting.
How to set the cutting unit attitude using a gauge bar for optimal performance.
Using a leveling plate to ensure accurate and consistent front roller adjustments.
Final steps to set the height-of-cut using a gauge bar across rollers.
Step-by-step guide for backlapping Reelmaster 5500 reel units.
Step-by-step guide for backlapping Reelmaster 6000 reel units.
Instructions for lubricating the cutting units with grease.
How to check and adjust reel bearings for end play.
Procedure for adjusting the SPA spring assembly.
Details on what products and conditions are covered and excluded by the warranty.
How to obtain service, owner duties, and general warranty terms.
Warranty terms specific to replacement parts.
To Next Page
General
