Toro 08120 User Manual

Form No. 3465-437 Rev A
Heater Kit
W orkman
®
UTX Utility V ehicle
Model No. 08120
Installation Instructions
Safety
Cooling System Safety
• Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
• Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
• Do not operate the machine without the covers
in place.
• Keep your ngers, hands and clothing clear of
rotating fan and drive belt.
• Shut of f the engine and remove the key before
performing maintenance.
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger . Replace any decal that is damaged or missing.
decal145-2229
145-2229
1. Fan—of f
3. Heat—low
2. Fan—on full
4. Heat—high
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420
Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3465-437*

Toro 08120 Specifications

General

Model	08120
Power Source	Electric
Air Speed	Up to 160 mph
Air Volume	Up to 230 cfm
Weight	6.9 lbs
Noise Level	70 dBA
Start Type	Electric

Summary

Safety

Cooling System Safety

Crucial safety guidelines for handling hot engine coolant and preventing accidental ingestion by children or pets.

Safety and Instructional Decals

Emphasizes the visibility and importance of safety decals for hazard identification and operational safety.

Installation

Loose Parts Verification

A checklist to confirm all necessary parts are included before commencing the installation process.

Preparing the Machine for Installation

Essential preliminary steps including parking, shifting, shutting off the engine, and allowing it to cool.

Installing the Heater Control Panel

Detailed instructions for cutting dashboard openings, drilling, and mounting the heater control panel and switches.

Cutting Vent Holes

Procedures for accurately drilling pilot holes and cutting larger holes for vent installation on the dashboard and floor.

Assembling the Heater Box Unit

Steps to connect vent hoses, Y-adapters, and vents to the main heater box assembly.

Mounting the Heater Box Assembly

Instructions for attaching the assembled heater box to the machine's frame and dash brackets, including washer bottle relocation.

Routing Coolant Hoses

Guidance on disconnecting, shortening, and reconnecting coolant hoses to the water valve and reservoir.

Installing the Wire Harness

Procedure for securely mounting the fuse cover and routing the kit's wire harness to the heater box and machine systems.

Connecting the Vehicle Battery

Final step to reconnect the negative battery cable to the battery post after the installation is complete.

Purging Air from Cooling System

How to properly fill the cooling system with coolant and run the engine to remove trapped air.

Operation

Controlling Fan Speed and Temperature

Explains how to use the control knobs to adjust fan speeds and regulate the air temperature in the cabin.

Maintenance

Servicing the Heater Air Filter

Details the service interval and steps for removing, inspecting, and installing a new heater air filter.