Toro 08120 - Installing the Wire Harness

7
Installing the W ire Harness
Parts needed for this procedure:
1
Pan-head bolt (#10-24 x 3/8 inch)
Procedure
1. Install the fuse cover (supplied with kit wire harness) onto the left side of the heater box with the pan-head
bolt (#10-24 x 3/8 inch) as shown in Figure 23 .
2. Route the kit wire harness as shown in Figure 23 .
g460700
Figure 23
1. T o airow switch (previously installed)
4. T o machine wire harness
2. Fuse cover—connected to the heater box with a pan-head
bolt (#10-24 x 3/8 inch)
5. T o heater box
3. T o fuse cover
13