5
Safety and Instruction Decals
Safety
decals and instructions are easily visible to the operator and are located near any
area of potential danger
. Replace any decal that is damaged or lost.
ON
BLADE
ON CHARGER
Installation
Mounting
the Charger (Model
51596 Only)
The
char
ger should be mounted indoors (such as a garage
or other dry place), near a power outlet, and out of reach
of children. Y
ou will need to supply three screws with
heads approximately 1/4 inch (6.3 mm) across and, if
mounting the char
ger on wall board, three wall anchors
for the screws
1.
Lay the provided template (page 15) against the wall
and mark the three hole locations as shown in
Figure 1.
m–4110
Figure
1
2. Drill
pilot holes as follows:
•
If installing the char
ger on wall board, plaster
, or
cement, drill three holes for the wall anchors (as
indicated by the wall anchor manufacturer) at the
marked locations.
•
If installing the char
ger on wood, drill three holes,
slightly smaller than the diameter of the screw
threads, at the marked locations.
3.
Install the screws as follows:
•
If installing the char
ger on wall board, plaster
, or
cement, insert the three wall anchors into the holes
then thread the screws into the wall anchors until
they are 1/8 inch (5 mm) from the edge of the wall
anchor (Fig. 2).
m–4111
1
2
3
1
2
Figure
2
1. Wall
Anchors
2. Screws
3.
1/8 inch
• If
installing the charger on wood, drive the screws
into the three holes until they are 1/8 inch (5mm)
from the wall.
A.
Place the keyhole slots in the back of the char
ger
over the three screws and push down on the char
ger
to secure it (Fig. 3).
m–4093
Figure
3
Mounting
the Charger (Model
51597 Only)
The
char
ger should be mounted indoors (such as a garage
or other dry place), near a power outlet, and out of reach
of children. Y
ou will need to supply two screws with
heads approximately 1/4 inch (0.6 cm) across and, if
mounting the char
ger on wall board, two wall anchors for
the screws
To Next Page
Loading...
