To Next PageTo Next Page
Need help?Do you have a question about the Toro 51643 and is the answer not in the manual?
Describes the function of flywheel, ignition coil, trigger module, and spark plug.
Details setting the air gap between the ignition coil and flywheel magnets for proper spark.
Instructions for adjusting the air gap for optimal spark and timing.
Explains the operation, removal, disassembly, reassembly, and installation of the recoil mechanism.
Details operation, inspection, disassembly, and reassembly of clutch shoes and flywheel.
Explains the centrifugal clutch operation and engagement speed.
Procedures for disassembly and reassembly of the clutch drum and housing.
Describes the two-stroke, port-to-port engine operation and its nine phases.
Steps to remove the engine from the drive tube assembly.
Detailed steps for disassembling the engine components.
Instructions for cleaning engine parts after disassembly.
Guidance on inspecting engine parts for wear and damage.
Steps for reassembling the engine after inspection and cleaning.
Procedure for installing the engine onto the drive tube assembly.
Covers disassembly and reassembly of the on/off switch and throttle control trigger.
Procedures for removing, installing, and adjusting the TC3000 handle.
Procedures for removing, installing, and adjusting the TC4000 handle.
Procedures for removing, installing, and adjusting the TC5000 handle.
Procedure for removing the gearbox from the drive tube.
Procedure for installing the gearbox onto the drive tube.
Covers removal and installation of the drive shaft.
Covers removal and installation of the drive tube.
Procedures for removing, replacing line, and installing the Leeco spool.
Covers disassembly, inspection, and reassembly of the Leeco trimmer head.
Covers line replacement, disassembly, and reassembly for the Kaaz head.
Covers line replacement, removal, and installation for the plastic fixed head.
Covers line replacement, removal, and installation for the metal fixed head.
Covers spool procedures and head disassembly/inspection for the Tap and Trim head.
Essential safety precautions and warnings for operating and servicing the trimmer.
Detailed technical specifications for the engine across different models.
Identifies causes and remedies for ignition spark failure.
Lists potential causes and solutions for engine flooding during startup.
Diagnoses issues related to fuel delivery problems to the engine.
Provides troubleshooting steps for reduced engine power.
Identifies causes and solutions for low engine compression.
Overview of the diaphragm-style carburetor's function and systems.
Procedure for adjusting the engine's idle speed.
How to adjust the high speed mixture screw for optimal fuel/air ratio.
General
