i
TC3000/TC4000 Air Gap Adjustment (cont'd)
Figure
60
TC300O/TC4000 Air Gap Adjustment Reassembly
1. Install the fan housing. Tighten the screws to
0.4
to
2.
Install the plastic fan housing cover using three
Phillips screws.
3.
Mount the engine on the drive tube as described
in Engine Installation on Drive Tube, page
45.
0.5
kg m
(35
to
43
in Ibs).
TC5000 Air Gap Adjustment Preparation
1. Remove the carburetor
as
described under
Carburetor Removal, page
14.
Figure 61
2.
Remove the three screws securing the muffler
cover and remove the cover.
Also
remove the
muffler at this time. TC5000 Air Gap Adjustment Reassembly
3.
Remove the screw securing the cylinder Cover to
1. Install the cylinder cover. Make sure that the coil
the cylinder. Remove the cover.
wire and grommet are properly positioned in the
Figure 62
cylinder cover slot.
2. Install the muffler and muffler cover.
TC5000 Air Gap Adjustment
3.
Install the carburetor as described in Section
I
1. The coil on the TC5000 is mounted to the inside
of
under Carburetor Installation, page 18.
the fan housing. The two coil mounting screws are
located near the base of the cylinder. Loosen both
coil mounting screws. See Figure 61
2.
Insert a feeler gauge between the coil and the
flywheel near one of the coil mounting screws. See
Figure 62. When the correct gap is achieved,
1.
Remove the engine from the drive tube as
tighten the screw with an
8
mm open end wrench. described under Engine Removal from Drive
Repeat this procedure for the other coil mounting
Tube,
page
40.
screw. This completes the air gap adjustment. 2. Remove the muffler cover and the cylinder cover.
Coil Removal
28
To Next Page
Loading...
