SECTION
18
HARNESSES
Standard and Deluxe Harness Assembly
1.
(TC3000
and
TC4000)
Slip the ring into the throttle
control. See Figure 161.
Figure 161
(TC5000)
Mount the clamp and ring assembly onto
the tube approximately
15
cm (6 inches) below the
isomount housing. Secure with the
nut
and
machine screw. See Figure 162.
3.
Adjust the harness
so
that the trimmer line or blade
rotates in a nearly level plane with a slight forward
tilt.
4.
(Deluxe Harness Only) Fasten the belt by
threading the loose end through the buckle.
See
Figure 163.
I
Figure 162
Figure 163
n
To Next Page
Loading...
