Toro 51643 - Section 8 Handle; TC3000 Handle - Removal from Drive Tube; TC3000 Handle - Installation on Drive Tube; TC3000 Handle - Adjustment

SECTION 8
TC3000 Handle Removal from Drive Tube
1. Remove the engine as described under Engine
2. Remove the grip and the control unit as described
under
Grip Removal from Drive Tube, page 46.
Removal from Drive Tube, page 40.
3. Loosen the handle knob. See Figure 112.
-HANDLE KNOB
Figure 112
4. Slide the handle up, and
off the drive tube.
(Soaping the drive tube may aid in removing the
handle.)
TC3000 Handle Installation on Drive Tube
1. With the engine, grip and control unit removed,
slide the handle onto the drive tube. (Soaping the
handle may facilitate installation.)
2. Insert the carriage bolt into either side of the handle
3. Install the control and grip as described under
Grip
4. Mount the engine as described under Engine
and secure with the knob.
Installation on Drive Tube, page 47.
Installation on Drive Tube, page 45.
TC3000 Handle Adjustment
1. Loosen the handle knob.
2. Adjust to the desired handle height but do not
cover the eye protection safety decal. See Figure
113.
Figure 113
3. Hand tighten the handle knob.
TC4000 Handle Removal From Tube
1. Loosen the five machine screws securing the two
handle mount halves. See Figure 114.
Figure 11
4
2. Remove the "J" handle from the mount halves.
3.
If desired, complete removal by removing the five
machine screws and the mounting halves from the
drive tube.
TC4000 Handle Installation on Drive Tube
1. Position the handle mount halves on the drive tube
between the eye protection and the
TC4000
decals. See Figure 115.