TC4000 Handle Installation on Drive Tube
(cont'd)
2.
Position the handle mount approximately
20
cm
(8
inches) from the control mount.
See
Figure
11
7.
HANDLE ADJUSTMENT AREA
HANDLE ADJUSTMENT AREA
Figure
115
Figure
11
7
Note: The mounting configuration shown in Figure
114
is most suitable for right handed operators.
Left handed operators may find
it
more
comfortable
if
the ounting halves are installed as
shown in Figure
116.
Figure
1 16
2.
Loosely fasten the handle mounts with the five
3.
Insert the
"J"
handle into the handle mount and
adjust as described under TC4000 Handle
Adjustment, page
49.
machine screws and locknuts.
TC4000 Handle Adjustment
Described below is a suggested "nominal" setting for the
TC4000
handle. Once a nominal position is set, the
1.
Loosen the five machine screws that secure the
handle mount to
the
drive tube about one turn
each.
operator may wish to adjust as desired.
3.
Adjust the "J" handle
so
that
it
has a slight rearward
4.
Tighten the machine screws to retain this setting.
tilt
(about
15
degrees).
TC5000 Handle Removal From Drive Tube.
1.
Remove the
two
screws securing the control to the
handle and remove the upper control half. Remove
the throttle cable from the trigger and pull the
throttle cable out of the grip. Loosely reinstall the
upper control half with the
two
machine screws.
2.
Pull
the
two
ignition kill wires out
of
the rear
of
the
grip. See Figure
11
8.
Figure
11
8
49
To Next Page
Loading...
