Starter Pulley Removal
3.
The starter pulley is threaded onto the crankshaft
1.
Remove the recoil starter as described under
and is removed by turning
it
counterclockwise.
If
Recoil Mechanism Removal, page
30.
the engine turns while trying to remove
it,
place a
piece
of
wood on one
of
the starter pulley ratchets
2.
Remove the starter pulley nut by turning
it
and
tap to loosen.
counterclockwise. See Figure
73.
Starter Pulley Installation
1.
Thread the starter pulley onto the crankshaft.
2.
Install the flywheel nut, tightening to
1.O
to
1.3
kg
3.
Install the recoil starter as described under Recoil
m
(87
to
113
in Ibs).
Mechanism Installation.
I
33
i
To Next Page
Loading...
