Toro 51643 - Headinstallation

Plastic Fixed Line Head Installation (cont’d)
NOTE: The following parts are required when installing
the plastic fixed line head on a
TC3000, or
TC5000 for the first time:
Part Number
41-5410
Cotter Pin 3272-1
A
CAUTION: Never attempt any
service
of the trimmer head
without first allowing the
engine and the implement to
come to a complete stop.
1. Mount the cutter head on the shaft. See Figure 149.
GRASS
WRAP
SHIELD
HEAD
Figure 149
2. Loosely secure with the hex nut.
NOTE: The nut has left hand threads
so it will be
necessary to turn
it counterclockwise to get it
started.
3. Insert a flat bladed screwdriver into the slot in the
top of the shield to prevent the cutter head from
rotating as shown in Figure
147.
4. Tighten the nut and install the cotter pin to prevent
5. Install the trimmer line as described under Plastic
the nut from backing out.
Fixed Line Head Line Replacement, page
63.
64