Coil Removal (cont'd) Coil Installation
3.
Remove the fuel tank as described under Fuel
1.
Install the trigger module using
two
machine
Tank Removal, page
20,
to gain access to screws. Be sure to install the rubber insulating
ignition wiring.
4.
Pull
out
the
two
male connectors leading into the
2.
Install the coil with the proper air gap by following
female connector found beneath the carburetor.
the procedure found under heading:
AIR
GAP
gasket beneath
it.
See Figure
63.
5.
Position the engine assembly
so
that the recoil
housing is resting on a hard, flat surface. Remove
the four Phillips head screws retaining the fan
housing with an impact wrench and
lift
off
the fan
housing. (The
TC5000
has the coil mounted in the
fan housing
so
be careful not to damage any wires
while removing the housing.)
6.
Remove the trigger module and gasket. See Figure
ADJUSTMENT,
page
27.
63.
Figure
63
29
To Next Page
Loading...
