Toro 51945 - User Manual

23 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

25.4 cc Gas Power Head

Model No. 51945—311000001 & Up

English (EN), French (FR), and Spanish (ES)

WARNING:

To reduce the risk of injury, the user must read and understand the operator’s manual. Save this manual.

Form No. 3369-610 Rev. A

If you have questions concerning

your trimmer, please call us

at 1-866-574-9242 (US) or

1-866-574-9243 (Canada).

Questions and Answers

A
Adam HamiltonJul 30, 2025
What to do if Toro Garden Machinery Accessories engine does not reach full speed and emits excessive smoke?
- E
  Elizabeth JohnsonJul 30, 2025
  If your Toro Garden Machinery Accessories engine isn't reaching full speed and is emitting excessive smoke, consider these possibilities: * Check the fuel mixture: Use fresh fuel and the correct 2-cycle oil mix. * Inspect the air filter: A dirty air filter can cause this issue, so clean it. * Examine the spark arrestor: A dirty spark arrestor screen might be the culprit; clean it.
K
kaylafullerAug 4, 2025
Why is oil dripping from the muffler of my Toro Garden Machinery Accessories?
- M
  Mr. Joseph Beltran MDAug 4, 2025
  Oil may drip from the muffler of your Toro Garden Machinery Accessories for several reasons. One reason might be that you are operating the product at part throttle; try operating it at full throttle. Another possible cause is the oil/fuel mixture; ensure you are using fresh fuel and the correct 2-cycle oil mix. Lastly, a dirty air filter could be the cause; in this case, clean the air filter.
W
williamperezAug 8, 2025
What to do if the starter cord pulls harder on Toro Garden Machinery Accessories?
- S
  Susan RamseyAug 8, 2025
  Contact an authorized service dealer.
J
johnvaldezAug 17, 2025
How to fix a Toro Brush Cutter engine that smokes and lacks power?
- S
  Steven NguyenAug 17, 2025
  If your Toro Brush Cutter's engine isn't reaching full speed and is emitting excessive smoke, check the fuel mixture. Use fresh fuel and the correct 2-cycle oil mix. Also, a dirty air filter or spark arrestor screen can cause this issue, so clean both the air filter and the spark arrestor screen.
R
Raymond HernandezAug 21, 2025
What to do if oil drips from the muffler of my Toro 51945 Brush Cutter?
- T
  Thomas KleinAug 21, 2025
  If oil is dripping from the muffler of your Toro Brush Cutter, it could be due to operating the product at part throttle; try operating it at full throttle. Another cause could be an incorrect oil/fuel mixture; ensure you are using fresh fuel and the correct 2-cycle oil mix. A dirty air filter may also contribute to this issue, so clean the air filter.
B
baileyandrewOct 25, 2025
Why Toro Garden Machinery Accessories engine will not start?
- S
  Shannon LopezOct 26, 2025
  If your Toro Garden Machinery Accessories engine won't start, there could be several reasons. It might be due to no spark. To check, remove the spark plug, reattach the cap, and lay it on the metal cylinder. Pull the starter cord and look for a spark at the tip. If there's no spark, try again with a new spark plug. Another reason might be no fuel. Push the primer bulb until it's full; if it doesn't fill, the fuel delivery system is blocked. Alternatively, the engine could be flooded. If so, remove the spark plug, turn the product so the spark plug hole faces the ground, ensure the choke is set to RUN, and pull the starter cord 10 to 14 times to clear excess fuel. Clean and reinstall the spark plug. With the trigger fully depressed, pull the cord 3 times. If it still doesn't start, set the ...
M
Michelle LewisNov 12, 2025
Why won't my Toro 51945 engine start?
- D
  Dwayne SantiagoNov 12, 2025
  If your Toro Brush Cutter's engine isn't starting, there could be several reasons. First, check for a spark. Remove the spark plug, reattach the cap, and lay it against the metal cylinder. Pull the starter cord to see if a spark appears at the tip. If not, try a new spark plug. Another reason could be no fuel is reaching the engine. Push the primer bulb until it's full. If it doesn't fill, the fuel delivery system might be blocked. Alternatively, the engine could be flooded. Remove the spark plug, turn the product so the spark plug hole faces the ground, ensure the choke is set to RUN, and pull the starter cord 10-14 times to clear excess fuel. Clean and reinstall the spark plug. Then, with the trigger fully depressed, pull the starter cord 3 times. If it still doesn't start, set the choke...

Summary

General Safety Rules

General Safety Instructions

Key safety guidelines for operating the trimmer, including protective gear and work area.

Specific Safety Rules

Trimmer Use Safety

Brushcutter and Blade Use Safety

Assembly

Unpacking and Inspection

Connecting Attachment to Upper Shaft

Step-by-step guide for attaching an implement to the power head.

Attaching the Front Handle

Detailed steps for attaching the front handle to the upper shaft.

Removing Attachment from Upper Shaft

Instructions on how to safely detach an implement from the power head.

Operation

Fueling and Refueling

Safety precautions and steps for fueling the power head.

Fuel Mixture Requirements

Details the required gasoline and oil mixture ratio for the 2-cycle engine.

Operating the Power Head

Guidance on how to properly hold and operate the power head.

Understanding Blade Thrust

Explains the concept of blade thrust and how to mitigate risks.

Starting the Product

Step-by-step instructions for starting the engine (cold and warm).

Stopping the Product

Steps for safely shutting down the engine.

Maintenance

Cleaning the Product

Servicing and Fuel Cap Check

Cleaning the Air Filter

Replacing Spark Arrestor

Replacing the Spark Plug

Idle Speed Adjustment

Troubleshooting

Engine Will Not Start

Possible causes and solutions for an engine that fails to start.

Poor Engine Performance and Smoke

Identifies causes and fixes for poor engine performance and smoke.

Muffler Oil Drips

Toro 51945 Specifications

General

Brand	Toro
Model	51945
Category	Brush Cutter
Language	English

Related product manuals