Toro 58604 - User Manual

Questions and Answers

K
Kathy GilbertSep 9, 2025
Why is there a constant buzzing sound while the drive-control lever is compressed on my Toro Tiller?
- T
  Teresa BullockSep 9, 2025
  A constant buzzing sound while the drive-control lever is compressed on your Toro Tiller could be due to several reasons: the drive-control lever may not be fully compressed, so ensure it is. The wire belt guide might be too close to the idler pulley; properly space it to clear the belt. Also, the belt tension could be incorrect, so check and adjust it. Finally, the belt may be stretched, requiring replacement.
N
nelsonstephenSep 12, 2025
How to control a Toro 58604 Tiller that jumps or lurches forward?
- A
  Adam JonesSep 12, 2025
  If your Toro Tiller is difficult to control and jumps or lurches forward, consider these factors: * The dirt may be too compact. Lower the engine speed. * The drag stake may be set too high. Lower the drag stake for greater resistance and control of the machine. * The tines may be installed incorrectly. Ensure the tines are installed with the edges forward.
J
Joanne HuntSep 13, 2025
Why is my Toro Tiller buzzing when I press the drive-control lever?
- M
  Mr. Adam JohnstonSep 13, 2025
  If you hear a constant buzzing sound when the drive-control lever is compressed on your Toro Tiller, check the following: * The drive-control lever may not be fully compressed. Fully compress the drive-control lever. * The wire belt guide may be too close to the idler pulley. Properly space the wire belt guide from the idler pulley to clear the belt. * The belt tension may be incorrect. Check the belt tension and adjust it as necessary. * The belt may be stretched. Replace the belt.
B
Brandon WalkerSep 14, 2025
Why does my Toro 58604 Tiller move forward when starting?
- M
  Michael TurnerSep 15, 2025
  If the Toro Tiller moves forward during starting, it could be due to: * The drive-control lever being compressed. Release the drive-control lever. * Incorrect belt tension. Check the belt tension and adjust it as necessary.
A
Alicia WelchSep 17, 2025
Why is there excessive heat in the transmission of my Toro 58604?
- H
  Haley ClarkSep 18, 2025
  Excessive heat in the transmission/tine area during tilling can occur if: * Vegetation or debris is caught in the tines. Remove the vegetation or debris. * The transmission fluid is low. Check the transmission fluid and add fluid as necessary.