Toro 71233 - Page 30

30
Problem Corrective actionPossible Causes
The engine overheats.
1. The engine load is excessive. 1. Reduce ground speed.
g
2. The oil level in the crankcase is
low.
2. Add oil to the crankcase.
3. The cooling fins and air
passages under the engine
blower housing are plugged.
3. Remove the obstruction from
the cooling fins and air
passages.
The machine does not drive.
1. The drive control is in the Push
position.
1. Move the drive control to the
Operate position.
2. The traction belt is worn, loose,
or broken.
2. Contact an Authorized Service
Dealer.
3. The traction belt is off of the
pulley.
3. Contact an Authorized Service
Dealer.