Toro 72908 - Page 33

g029957
Figure 34
1. Anti-scalp roller 4. Flange nut
2. Spacer
5. Bolt
3. Bushing
Machines with Rear Discharge
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
35 and Figure 36 .
g024242
Figure 35
1. Flange nut 3. Bushing
2. Anti-scalp roller 4. Bolt
g024243
Figure 36
1. Bolt 3. Anti-scalp roller
2. Bushing 4. Flange nut
Adjusting the Skid(s)
For Machines with Rear Discharge
Mount the skids in the lower position when operating
in height of cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height of cuts
lower than 64 mm (2-1/2 inches).
Note: When the skids become worn, switch the skid
to the opposite sides of the mower , ipping them
over . This allows you to use the skids longer before
replacing them.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the carriage bolts and nuts from each
skid ( Figure 37 ).
33