To Next PageTo Next PageWhat to do if my Toro Lawn Mower won't drive?
If your Toro Lawn Mower isn't driving, check these items: * Ensure the bypass valves are tightly closed. * Change the pump belt if it is worn, loose, or broken. * Change the pump belt if it is off a pulley. * Replace the idler spring if it is broken or missing. * Add hydraulic oil to the reservoirs or allow it to cool down if the hydraulic oil level is low or too hot.
Why Toro 72907 Lawn Mower blades do not rotate?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken mower deck belt; in this case, install a new deck belt. Also, check if the mower deck belt is off a pulley and install the mower deck pulley, checking the idler pulley, idler arm, and spring for correct position and function. Inspect the pump drive belt for wear, looseness, or breakage, and check the belt tension or install a new belt. If the idler spring is broken or missing, replace it.
What to do if my Toro Lawn Mower engine does not start?
If your Toro Lawn Mower engine doesn't start, starts hard, or fails to keep running, several factors could be at play. First, ensure the fuel tank isn't empty and the fuel-shutoff valve is open. Check that the oil level in the crankcase is sufficient and the throttle is positioned midway between the SLOW and FAST settings. Also, a dirty fuel filter or air cleaner can cause issues, so replace or clean them as needed. Inspect the spark plug, adjusting or replacing it if it's fouled or improperly gapped, and verify the spark-plug wire is securely connected. Finally, check the seat-switch indicator, replacing the seat if necessary.
Why does my Toro 72907 pull to the left or right?
If your mower pulls to one side, the tracking may need adjustment, or the tire pressure in the drive tires may not be correct. Adjust the tracking and the tire pressure in the drive tires.
Why does my Toro Lawn Mower vibrate abnormally?
Abnormal vibration in your Toro Lawn Mower can be caused by several factors. Check if the cutting blades are bent or unbalanced, and if so, install new ones. Ensure the blade mounting bolt and engine mounting bolts are tightened securely. Also, verify that the engine pulley, idler pulley, or blade pulley is not loose and tighten the appropriate pulley if needed.
Why aren't the blades rotating on my Toro 72907 Lawn Mower?
If the blades on your Toro Lawn Mower aren't rotating, check the following: replace the deck belt if it is damaged, worn, loose, or broken. Install the mower belt on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Check the belt tension or install a new belt if the pump drive belt is worn, loose, or broken. Replace the spring if the idler spring is broken or missing.
Why Toro 72907 engine loses power?
If your Toro Lawn Mower engine is losing power, consider these potential causes. First, the engine load might be excessive, so reduce the ground speed. A dirty air cleaner can also cause power loss, so clean the air-cleaner element. Additionally, check the oil level in the crankcase and add oil if it's low. Finally, ensure the cooling fins and air passages above the engine are free from obstructions.
Why Toro 72907 machine does not drive?
If your Toro Lawn Mower isn't driving, start by checking that the bypass valves are closed tight. Inspect the pump belt for wear, looseness, or breakage, and change the belt if needed. Also, ensure the pump belt is properly on the pulley. If the idler spring is broken or missing, replace it. Finally, check the hydraulic-fluid level and add fluid to the reservoirs if it's low, or let it cool down if it's too hot.
Why don't the blades rotate on my Toro 72907?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken mower deck belt, the mower deck belt being off the pulley, a worn, loose, or broken pump drive belt, or a broken or missing idler spring. Try installing a new deck belt, installing the mower deck pulley and checking the idler pulley, idler arm, and spring for correct position and function, checking the belt tension or installing a new belt, and replacing the spring.
Why won't my Toro 72907 starter crank?
If the starter on your Toro Lawn Mower doesn't crank, there are several possible reasons. First, ensure the blade control switch (PTO) is disengaged and the parking brake is set. Also, make sure the drive levers are in the neutral lock position and that you are seated on the seat. If these aren't the problem, check if the battery is dead and charge it if necessary. Inspect the electrical connections for corrosion or looseness, and replace the fuse if it's blown.
General| Engine Type | 4-Cycle |
|---|---|
| Start Type | Recoil |
| Deck Material | Steel |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Engine | Briggs & Stratton |
| Cutting Width | 22 inches |
| Drive System | Rear-wheel drive |
| Fuel Tank Capacity | 0.95 quarts |
| Oil Capacity | 20 oz |
