1 1. Move the motion-control levers to the REVERSE
position and while applying slight pressure to
the lever , allow the reverse-indicator springs to
bring the levers back to neutral.
Note: The wheels should stop turning or slightly
creep in reverse.
12. Shut of f the machine.
13. Remove the jumper wire from the wire harness
and plug the connector into the seat switch.
14. Remove the jack stands.
15. Raise the mower deck and install the
height-of-cut pin.
16. Check and ensure that the machine does
not creep in neutral with the parking brake
disengaged.
Adjusting the
Motion-Control Damper
Y ou can adjust the top damper-mounting bolt to obtain
the desired motion-control lever resistance. Refer to
Figure 99 for mounting options.
g008620
Figure 99
Right Motion Control Shown
1. T orque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (rmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the
Motion-Control
Neutral-Lock Pivot
Y ou can adjust the anged nut to obtain the desired
motion-control lever resistance when moving it to
the N EUTRAL -L OCK position. See Figure 100 for
adjustment options.
1. Loosen the jam nut.
2. T ighten or loosen the anged nut to the desired
feel.
• For more resistance, tighten the anged nut.
• For less resistance, loosen the anged nut
3. T ighten the jam nut.
g008621
Figure 100
1. Flanged nut 2. Jam nut
67
To Next Page
Loading...