Need help?Do you have a question about the Toro groundmaster 7210 and is the answer not in the manual?
General| Number of Blades | 3 |
|---|---|
| Engine | Kubota Diesel |
| Cutting Width | 72 inches |
| Transmission | Hydrostatic |
| Fuel Capacity | 12.5 gallons |
| Turning Radius | 18 inches |
| Standard Tires (rear) | 26x12-12 |
Essential safety guidelines for operating the machine to prevent injuries.
Pre-operation checks and safe operating procedures for hazard avoidance.
Precautions and techniques for safe operation on slopes to prevent rollovers.
Identification and function of main control levers and switches.
Emphasis on reading safety instructions and understanding hazards.
Safe procedures for adding fuel, including warnings about flammability.
Safety warnings and instructions for operating with the ROPS.
How to engage and disengage the parking brake.
Safety precautions and procedures for loading the machine onto trailers.
Step-by-step guide to starting the engine safely.
Steps to safely stop the engine and secure the machine.
Instructions for operating the motion-control levers and driving safely.
Sequence for stopping the machine and securing it.
How to raise and lower the mower deck using the deck-lift switch.
Procedure for engaging and disengaging the power take-off (PTO) for blades.
Explanation of the DPF regeneration process and its importance.
How soot accumulates in the DPF and system warnings.
Interpreting engine warnings related to soot levels in the DPF.
How ash accumulates in the DPF and system advisories.
Understanding InfoCenter advisories for ash accumulation.
DPF regeneration occurring during normal operation.
DPF regeneration processes requiring computer intervention.
Conditions and procedure for parked DPF regeneration.
Procedure for recovery regeneration when parked regeneration is ignored.
Steps to prepare for and perform parked or recovery regeneration.
Daily procedure to test the functionality of all safety interlock switches.
Table outlining maintenance tasks based on service intervals (hours/years).
Procedure for checking the engine oil level using the dipstick.
Steps for draining old oil and replacing the oil filter.
Procedure for adjusting drive wheels to ensure neutral position accuracy.
Information on what is covered under the warranty and its duration.
Owner's duties for maintenance and conditions not covered by warranty.
To Next Page