8
Check
Before Operating
Each time before operating your tractor, check the
following:
• Fuel level
• Engine oil level
• Debris on the (3) air intake screens
• Debris in the engine area
• Debris on the rear transaxle cover
• The safety interlock system
• The brake
Some of these steps will require that you open the
hood or remove the side panels on the tractor.
Opening
the Hood
To open the hood:
1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to “STOP” to stop the engine. Remove the
ignition key.
2. Push the hood latch (Fig. 1), located just above
the indicator light panel, to the left.
3. Raise the hood to full height.
m–3314
1
Figure 1
1. Hood
latch
POTENTIAL
HAZARD
• Components under the hood will be hot if
the tractor has been running.
WHAT CAN HAPPEN
• Touching hot components can cause burns.
HOW TO AV
OID THE HAZARD
• Allow the tractor to cool before performing
maintenance or touching components
under the hood.
To Next Page
Loading...
