Maintenance
47
1. Remove the battery from the chassis; refer to
Removing the Battery, page 45.
2. Check the electrolyte level; refer to Checking the
Electrolyte Level, page 44, steps 2–4.
3. Remove the cell cover from the battery and
connect a 3– to 4–amp battery charger to the
battery posts. Charge the battery at a rate of 4
amperes or less for 4 hours (12 volts). Do not
overcharge the battery. Install the cell cover after
the battery is fully charged.
POTENTIAL HAZARD
• Charging the battery produces gasses.
WHAT CAN HAPPEN
• Battery gasses can explode.
HOW TO AVOID THE HAZARD
• Keep cigarettes, sparks and flames away
from battery.
4. Install the battery in the chassis; refer to
Installing the Battery, page 46.
To Next Page
Loading...