Toro 74165 - Positioning the Seat; Pushing the Machine by Hand

20
4. Reinstall the stud nut and washer (Fig. 17).
5. Repeat the adjustment on the other gage wheels.
m–4167
1
2
3
4
5
Figure 17
1. Gage wheel
2. Stud
3. Washer
4. Nut
5. Wheel nut and washer.
Do not remove.
Adjusting the Center Rollers
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the bolt and
nut (Fig. 18).
4. Select a hole so that the gage wheel is positioned to the
nearest corresponding height-of-cut desired (Fig. 18).
Note: Do not adjust the rollers to support the deck.
5. Reinstall the bolt, center rollers, and nut (Fig. 18).
m–4124
1
2
3
Figure 18
1. Center rollers and spacer
2. Nut
3. Bolt
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Fig. 19).
2. Slide the seat to the desired position and release the
lever to lock the seat in position.
1
m–3655
Figure 19
1. Adjustment lever
Pushing the Machine by Hand
Important Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.