Need help?Do you have a question about the Toro 74243 and is the answer not in the manual?
General| Cutting Width | 42 inches |
|---|---|
| Transmission | Hydrostatic |
| Deck Material | 10-gauge steel |
| Fuel Capacity | 3 gallons |
| Turning Radius | 18 inches |
| Warranty | 3-year limited |
Essential safety procedures for operating the Z Master mower.
Explains signal words like Danger, Warning, and Caution for hazard identification.
Specific safety rules and techniques for mowing on slopes.
Instructions for using the ROPS for operator safety during rollovers.
Guidelines for selecting and using appropriate gasoline and oil.
Procedures for filling the fuel tank and checking engine oil level.
Detailed steps for operating the mower with the ROPS.
Critical warnings regarding slope operation and rollover prevention.
Information on noise levels and the need for hearing protection.
Steps for setting and releasing the parking brake for safe operation.
Step-by-step guide for starting the mower engine safely.
Instructions for properly shutting down the mower engine.
How to engage and disengage the PTO for power transmission.
Procedures to verify the safety interlock system is functioning correctly.
Instructions for controlling mower movement forwards and backwards.
Steps to adjust the mower deck cutting height.
How to use the lift assist lever for raising the mower deck.
Guide for adjusting anti-scalp rollers for deck flotation.
Recommended positions for the flow baffle based on conditions.
Instructions for adjusting the operator's seat for comfort and control.
How to unlatch the seat for access to the machine.
Safe procedures for manually pushing the mower.
Information on using the side discharge deflector safely.
Guidelines for safely transporting the mower on a trailer or truck.
Precautions and procedures for safely loading the mower.
Step-by-step guide for safely driving the mower onto the Z Stand.
Steps for safely driving the mower off the Z Stand.
How to inspect blades for sharpness, damage, and wear.
Procedure to check if mower blades are bent or damaged.
Instructions on how to sharpen mower blades safely and effectively.
Steps for correctly installing mower blades onto the spindle shaft.
Procedures for cleaning or replacing air cleaner filters.
Steps for draining and refilling the engine oil.
How to check and maintain the correct engine oil level.
Procedures for replacing the engine oil filter.
How to inspect and check the spark plug gap.
Steps for replacing the fuel filter.
Instructions for safely draining the fuel tank.
Locations and methods for greasing and lubricating the mower.
Specific instructions for lubricating the front caster pivots.
Weekly lubrication procedure for cutting unit spindles.
How to clean engine screens, oil coolers, and fins.
Maintaining correct tire pressure for even cutting.
Procedure for checking and torquing the wheel hub slotted nut.
How to check and maintain the hydraulic fluid level.
Steps for replacing the hydraulic system filter.
Procedure to bleed air from the hydraulic system.
Inspecting hydraulic lines for leaks and damage.
How to adjust motion control levers for neutral alignment.
Steps to set the neutral position for the right hydraulic pump.
Steps to set the neutral position for the left hydraulic pump.
How to adjust the mower's tracking for straight travel.
Procedure to ensure the parking brake is properly adjusted.
Information on locating and replacing fuses.
Procedures for checking electrolyte level and installing the battery.
Safe steps for removing the battery from the machine.
Instructions for adding distilled water to battery cells.
Guidelines for safely charging the mower battery.
How to adjust the mower deck for side-to-side levelness.
Adjusting the spring for proper mower lift assist.
Checking mower belts for wear and damage.
Steps for replacing a worn or damaged mower belt.
How to adjust the belt tension for optimal performance.
Solutions for engine not starting, starting hard, or stopping.
Troubleshooting steps for engine power loss and overheating.
Solutions for the mower not driving or having abnormal vibration.
Diagnosing and fixing uneven cutting height and blade rotation problems.
To Next Page
