Toro 74252 - Stopping the Machine; Adjusting the Height-Of-Cut; Using the Lift Assist Lever

T he far ther y ou mo v e the traction control
lev ers in either direction, the faster the mac hine
will mo v e in that direction.
T o stop , pull the motion control lev ers to the
neutral position.
Figure 16
1. Motion control
lever-neutral lock position
3. Forward
2. Center un-lock position 4. Backward
Driving Backward
1. Mo v e the lev ers to the center , un-loc k ed
position.
2. T o g o bac kw ard, slo wly pull the motion control
lev ers rearw ard ( Figure 16 ).
T o g o straight, apply equal pressure to both
motion control lev ers ( Figure 16 ).
T o tur n, release pressure on the motion control
lev er to w ard the direction y ou w ant to tur n
( Figure 16 ).
T o stop , push the motion control lev ers to the
neutral position.
Stopping the Machine
T o stop the mac hine , mo v e the traction control
lev ers to neutral and mo v e to loc k ed position,
diseng ag e the po w er tak e off (PTO), and tur n the
ignition k ey to off .
Set the parking brak e when y ou lea v e the mac hine;
refer to Setting the P arking Brak e . R emember to
remo v e the k ey from the ignition switc h.
Childr en or bystander s may be injur ed if
they mo v e or attempt to operate the tractor
while it is unattended.
Al w ays r emo v e the ignition k ey and set the
par king brak e when lea ving the machine
unattended, ev en if just f or a few min utes.
Adjusting the Height-of-Cut
T he height-of-cut is adjusted from 1-1/2 to 5 inc h
(38 to 127 mm) in 1/4 inc h (6 mm) increments
b y relocating the clevis pin into different hole
locations .
1. Raise the height-of-cut lev er to the transpor t
position (also the 5 inc h (127 mm) cutting
height position) ( Figure 17 ).
2. T o adjust, remo v e the clevis pin from the
height-of-cut brac k et ( Figure 17 ).
3. Select a hole in the height-of-cut brac k et
cor responding to the height-of-cut desired
and, inser t the clevis pin ( Figure 17 ).
4. Mo v e the lev er to the selected height.
Figure 17
1. Height of cut lever 2. Clevis Pin
Using the Lift Assist Lever
T he lift assist lev er is used along with the
height-of-cut lev er for raising the mo w er . T his
allo ws for easier raising of the mo w er .
1. Place y our foot onto lift assist lev er .
2. Press on the lift assist lev er while pulling up on
the height-of-cut lev er ( Figure 18 ).
22