Toro 74261 - User Manual

64 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Form No. 3356-190 Rev B

Z500 Z Master, with 52in

or 60in Turbo Force® Side

Discharge Mower or a Z557 Z

Master, with 72in Turbo Force®

Side Discharge Mower

Model No. 74261 —Serial No. 270000001 and Up

Model No. 74262 —Serial No. 270000001 and Up

Model No. 74263 —Serial No. 270000001 and Up

Register your product at www.Toro.com Original Instructions (EN)

Table of Contents

Questions and Answers

G
Gabriel MasonSep 12, 2025
How to stop abnormal vibration in Toro 74261 Lawn Mower?
- C
  Caleb SwansonSep 12, 2025
  To address abnormal vibration in your Toro Lawn Mower, check the following: * Bent or unbalanced cutting blades: Install new cutting blade(s). * Loose blade mounting bolt: Tighten the blade mounting bolt. * Loose engine mounting bolts: Tighten the engine mounting bolts. * Loose engine pulley, idler pulley, or blade pulley: Tighten the appropriate pulley. For a damaged engine pulley, bent blade spindle, or loose/worn motor mount, contact an Authorized Service Dealer.
R
Rebecca ChristensenSep 12, 2025
Why does my Toro Lawn Mower engine overheat?
- W
  weissoliviaSep 12, 2025
  Your Toro Lawn Mower engine may overheat due to several reasons. The engine load could be excessive, so try reducing the ground speed. Also, check the oil level in the crankcase and add oil if it is low. Another possible cause is that the cooling fins and air passages above the engine are plugged, so remove any obstructions.
M
Margaret WrightSep 10, 2025
How to fix uneven cutting height on my Toro Mower?
- M
  Mark StewartSep 10, 2025
  To address uneven cutting height with your Toro Mower: * Sharpen the blades if they are not sharp. * Replace bent cutting blades. * Level the mower from side to side and front to rear. * Adjust the gage wheel height if the anti-scalp roller is not set correctly. * Clean the underside of the mower if it's dirty. * Adjust the tire pressure if it is incorrect.
A
Andrew BergerSep 9, 2025
What to do if Toro Mower blades do not rotate?
- A
  Aaron JohnsonSep 9, 2025
  If your Toro Mower blades do not rotate, ensure that the mower belt is properly installed and check the adjusting plate, idler arm and spring, and belt guides for correct position. If the mower belt is worn, loose, or broken, install a new one.
W
wilsonrichardSep 8, 2025
Why does my Toro Mower engine lose power?
- S
  sethmillerSep 8, 2025
  If your Toro Mower engine loses power, consider the following: 1. The engine load might be excessive, so reduce ground speed. 2. The air cleaner could be dirty; clean the air cleaner element. 3. The oil level in the crankcase might be low; add oil. 4. Cooling fins and air passages might be blocked; remove any obstructions. 5. Spark plugs could be faulty; install new, correctly gapped spark plugs. 6. The fuel filter could be dirty; replace it.
K
Kent WrightAug 23, 2025
Why won't my Toro Lawn Mower engine start?
- M
  morganrossAug 23, 2025
  There are several reasons why your Toro Lawn Mower engine might not start. It could be due to an empty fuel tank, which requires you to fill the tank with fuel. Alternatively, the air cleaner might be dirty, in which case you should clean or replace the air cleaner element. Another potential cause is dirt in the fuel filter, which means you should replace the fuel filter. For issues related to dirt, water, or stale fuel in the fuel system, it is best to contact an Authorized Service Dealer.
B
Brian BaileySep 6, 2025
What to do if Toro Lawn Mower engine loses power?
- M
  Matthew McclureSep 6, 2025
  If your Toro Lawn Mower engine loses power, there are several potential causes. Start by reducing the ground speed, as the engine load may be excessive. Check the air cleaner and clean it if it's dirty. Ensure the oil level in the crankcase is adequate by adding oil if it's low. Remove any obstructions from the cooling fins and air passages under the engine blower housing. Inspect the spark plugs, replacing them if they are pitted, fouled, or have an incorrect gap. Replace the fuel filter if it's dirty. For issues related to dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
E
Emily HammondSep 5, 2025
Why Toro 74261 starter does not crank?
- P
  Paul MortonSep 5, 2025
  Your Toro Lawn Mower's starter might not crank due to several reasons. The blade control (PTO) may be engaged, so disengage it. Ensure the parking brake is set and that you are seated on the seat. The battery might be dead, requiring a charge. Check for corroded or loose electrical connections and replace the fuse if it's blown. If the relay or switch is defective, contact an Authorized Service Dealer.
M
Michael LinSep 4, 2025
How to fix an uneven cutting height on my Toro Riding mower?
- G
  Gina TerrellSep 4, 2025
  To address an uneven cutting height with your Toro Riding mower, start by sharpening the blades. If the cutting blades are bent, replace them. Ensure the mower is level from side-to-side and front-to-rear. Adjust the anti-scalp roller correctly and clean the underside of the mower. Finally, adjust the tire pressure. If the blade spindle is bent, contact an Authorized Service Dealer.
J
Julie KhanSep 3, 2025
What to do if my Toro Riding mower does not drive?
- C
  Cynthia MoodySep 3, 2025
  If the Toro Riding mower does not drive, first check the hydro fluid level and add fluid to the reservoir if it's low. Also, verify that the tension spring is connected. If these steps don't resolve the issue, the traction belt may be worn, loose, or broken, or it might be off the pulley, in that case you should contact an Authorized Service Dealer.

Toro 74261 Specifications

General

Brand	Toro
Model	74261
Start Type	Recoil
Deck Material	Steel
Engine Type	Gasoline
Engine	Briggs & Stratton
Cutting Width	22 inches
Drive System	Rear-wheel drive
Oil Capacity	20 oz

Related product manuals

Preview: Toro 74265TE

Preview: Toro Z593-D Z Master 74264

Toro Z593-D Z Master 74264

Preview: Toro Z580-D Z Master 74266

Toro Z580-D Z Master 74266

Preview: Toro 74251

Preview: Toro 74274