Toro 74269 - Drive System Maintenance; Adjusting the Tracking

Figure56
1.Frontenginepanel2.Knob
2.Toreplaceafuse,pulloutonthefusetoremoveit
(Figure57).
Figure57
1.Accessory-20amp3.Ignition-30amp
2.Clutch-10amp
4.Alternator-50amp
DriveSystem
Maintenance
AdjustingtheTracking
Themachinehasaknobforadjustingthetracking
locatedundertheseat.
Important:Adjustthehandleneutralandhydraulic
pumpneutralbeforeadjustingthetracking.Refer
toAdjustingtheHandleNeutralinControlsSystem
MaintenanceandAdjustingtheHydraulicPump
NeutralinHydraulicSystemMaintenance.
1.Pushbothcontrolleversforwardthesamedistance.
2.Checkifthemachinepullstooneside.Ifitdoes,
stopthemachineandsettheparkingbrake.
3.Unlatchtheseatandtilttheseatforwardtoaccess
thetrackingknob.
Note:Determinetheleftandrightsidesofthe
machinefromthenormaloperatingposition.
4.Tomakethemachinegoright,turntheknobtowards
therightsideofthemachine.Referto
Figure58.
5.Tomakethemachinegoleft,turntheknobtowards
theleftsideofthemachine.Referto
Figure58.
6.Repeatadjustmentuntilthetrackingiscorrect.
Figure58
1.Trackingknob4.Turnthiswaytotrackright
2.Hydraulictank
5.Turnthiswaytotrackleft
3.Hydraulicpumps
42