Toro 74444 - Adjusting the Height-of-Cut; Adjusting the Anti-Scalp Rollers

Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethetractorwhileit
isunattended.
Alwaysremovetheignitionkeyandsetthe
parkingbrakewhenleavingthemachine
unattended,evenifjustforafewminutes.
AdjustingtheHeight-of-Cut
Theheight-of-cutisadjustedfrom1-1/2to4-1/2inch
(38to114mm)in1/4inch(6mm)incrementsby
relocatingtheclevispinintodifferentholelocations.
1.Raisetheheight-of-cutlevertothetransport
position(alsothe4-1/2inch(114mm)cutting
heightposition)(Figure19).
2.Toadjust,removetheclevispinfromthe
height-of-cutbracket(Figure19).
3.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
inserttheclevispin(Figure19).
4.Movethelevertotheselectedheight.
Figure19
1.Heightofcutlever2.ClevisPin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,adjustthe
heightoftheanti-scalprollers.
1.DisengagethePTO,movethemotioncontrol
leverstotheneutrallockedpositionandsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,adjusttherollers
byremovingtheangenut,bushing,spacer,and
bolt(Figure20,Figure21andFigure52).
Note:Thetwomiddlerollerswillnothaveaspacer
(Figure21).
4.Selectaholesotheanti-scalprollerispositionedto
thenearestcorrespondingheight-of-cutdesired.
5.Installtheangenutbushing,spacer,andbolt.
Torqueto40-45ft-lb(54-61N-m)(Figure20,
Figure21andFigure52).
6.Repeatthisadjustmentontheotheranti-scalp
rollers.
Figure20
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
20