What to do if my Toro Lawn tractor does not drive?
If your Toro Lawn tractor does not drive, ensure the drive control is in the Operate position, not the Push position. If the traction belt is worn, loose, or broken, or if it's off the pulley, contact an Authorized Service Dealer.
Why is my Toro Lawn Mower cutting height uneven?
Uneven cutting height on your Toro Lawn Mower can be addressed by setting the tire pressure, adjusting the height adjustment cable rod assembly, cleaning the underside of the mower, and tightening the blade mounting screws.
Why won't my Toro 74582 Lawn Mower engine start?
Your Toro Lawn Mower engine might not start due to several reasons. Ensure you are seated, the fuel tank isn't empty (fill it with gasoline if it is), the air cleaner isn't dirty (clean or replace it), the spark plug wire is properly connected, the spark plug isn't damaged (replace if needed), the choke is closing properly (adjust the throttle cable), the fuel filter isn't clogged (replace if needed), the fuel shut-off valve is open, or the idle speed and mixture aren't set correctly (adjust them accordingly).
What to do if my Toro 74582 engine will not start?
If your Toro Lawn Mower engine won't start, starts with difficulty, or stops running, make sure you're sitting on the seat. Also, check that the fuel tank isn't empty and refill it with gasoline if needed. Another cause might be a dirty air filter, which you should clean or replace. Ensure the spark plug wire is properly connected to the spark plug. Inspect the spark plug itself for damage or incorrect gap, replacing it if necessary. Check if the choke is closing correctly and adjust the throttle cable if it is not. Replace the fuel filter if it's clogged with dirt. Finally, verify that the fuel shut-off valve is open.
What to do if my Toro 74582 engine loses power?
If your Toro Lawn Mower engine is losing power, try reducing your ground speed. You can also clean the air cleaner element, add engine oil to the crankcase, and remove any obstructions from the cooling fins and air passages. Other solutions include installing a new, correctly-gapped spark plug, cleaning or replacing the fuel cap, and replacing the fuel filter.
How to fix abnormal vibration in my Toro Lawn Mower?
Abnormal vibration in your Toro Lawn Mower can be caused by several issues: * Bent or unbalanced blades (install new blades). * Loose blade mounting screws (tighten them). * Loose engine mounting bolts (tighten them). * A loose engine pulley, idler pulley, or blade pulley (tighten the appropriate pulley). * A damaged blade drive belt (install a new one). If the engine pulley is damaged, contact an Authorized Service Dealer.
Why is my Toro 74582 vibrating abnormally?
Abnormal vibration in your Toro Lawn Mower could stem from several issues. Try installing new blades, tightening the blade mounting screws, tightening the engine mounting bolts, and tightening the appropriate pulley.
What causes my Toro Lawn Mower engine to overheat?
Your Toro Lawn Mower engine could be overheating because the engine load is too high (reduce ground speed), the oil level in the crankcase is low (add oil), or the cooling fins and air passages under the engine blower housing are blocked (remove any obstructions).
What to do if my Toro Lawn tractor engine will not start?
If your Toro Lawn tractor's engine won't start, starts hard, or fails to keep running, make sure you are sitting on the seat. Also, check if the fuel tank is empty and fill it with gasoline if needed. Other potential causes include a dirty air cleaner (clean or replace it), a loose or disconnected spark plug wire (install it), a faulty spark plug (install a new, correctly-gapped one), a choke that is not closing (adjust the throttle cable), dirt in the fuel filter (replace it), an incorrect idle speed or mixture (adjust the carburetor), a closed fuel shut-off valve (open it). If there is dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
How to fix a Toro 74582 engine that loses power?
If your Toro Lawn Mower engine loses power, start by reducing your ground speed, as the engine load may be too high. Check the air cleaner element and clean it if it's dirty. Ensure the oil level in the crankcase is adequate; add oil if it's low. Also, inspect the cooling fins and air passages under the engine blower housing, removing any obstructions. Replace the spark plug if it's damaged or incorrectly gapped. Clean or replace the fuel cap to ensure the vent hole isn't blocked. Finally, replace the fuel filter if it's clogged with dirt.
General| Engine | Briggs & Stratton |
|---|---|
| Deck Material | Steel |
| Start Type | Recoil |
| Cutting Width | 22 inches |
| Fuel Capacity | 0.95 quarts |
| Fuel Tank Capacity | 3 gallons |
| Warranty | 2 years limited |
To Next Page