Toro 74723 - Stopping the Machine; Adjusting the Height-Of-Cut; Adjusting the Anti-Scalp Rollers

StoppingtheMachine
Tostopthemachine,movethemotion-control
leverstoNEUTRALandoutwardtothePARKposition,
disengagetheblade-controlswitch,ensurethatthe
throttleisintheFASTposition,andturntheignition
keytoOFF.Removethekeyfromtheignitionswitch.
WARNING
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethemowerwhile
itisunattended.
Alwaysremovetheignitionkeyandmove
themotion-controlleversoutwardtothe
PARKpositionwhenleavingthemachine
unattended,evenifjustforafewminutes.
AdjustingtheHeight-of-Cut
Note:Thetransportpositionisthehighest
height-of-cutpositionat115mm(4-1/2inches)as
showninFigure18.
g027504
Figure18
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheightofcut,adjustthe
heightoftheanti-scalprollers.
Note:Adjusttheanti-scalprollerssothattherollers
donottouchthegroundinnormal,atmowingareas.
1.Disengagetheblade-controlswitch(PTO),move
themotion-controlleverstotheNEUTRAL-LOCK
position,andsettheparkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Adjusttheanti-scalprollersasshowninFigure
19tomatchtheclosestheight-of-cutposition.
g010233
Figure19
1.Anti-scalproller3.Flangenut
2.Bolt4.Holespacing
24