Toro 74923 Z Master 6000 - Hydraulic System Maintenance; Servicing the Hydraulic System

HydraulicSystem
Maintenance
ServicingtheHydraulic
System
HydraulicFluidType:Toro
®
HYPR-OIL
™
500hydraulic
oilorMobil
®
115W-50.
Important:Usethespecieduid.Otheruidscould
damagethehydraulicsystem.
EachHydraulicSystemOilCapacity:1.5L(52oz)per
sidewithlterchange
CheckingtheHydraulicFluid
ServiceInterval:Every50hours—Checkthehydraulic-uid
level.
1.Positionthemachineonalevelsurface.
2.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition,
andsettheparkingbrake.
3.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
4.Allowtheengineandthehydraulicsystemtocoolfor
10minutes.
Note:Theoillevelonthedipstickisincorrectwhen
theoilischeckedandtheunitishot.
5.Movetheseatforward.
6.Cleantheareaaroundthedipsticksofhydraulic-system
reservoirs(Figure86).
7.Remove1dipstickfromthehydraulicreservoir(Figure
86).
8.Wipethedipstickoffandthreadthedipstickintothe
reservoir.
9.Removethedipstickandlookattheend(Figure86).
Important:Donotoverllthehydraulicunits
withoilasdamagemayoccur.Donotrunthe
machinewiththeoilbelowtheaddmark.
10.Iftheoillevelisattheaddmark,slowlypouronly
enoughoilintothehydraulicreservoirtoraisethelevel
tothefullorHline.
11.Installthedipstick.
12.Repeattheprocedurefortheoppositedipstick.
G015459
H
3
4
Figure86
Eitherdipstickisusedinthemachine
1.Full3.H—meanshighlevel
2.Add4.Dipsticklocationsunder
seat
WARNING
Hydraulicuidescapingunderpressurecan
penetrateskinandcauseinjury.
•Ifhydraulicuidisinjectedintotheskinit
mustbesurgicallyremovedwithinafew
hoursbyadoctorfamiliarwiththistype
ofinjury.Gangrenemayresultifthisis
notdone.
•Keepyourbodyandhandsawayfrom
pinholeleaksornozzlesthateject
high-pressurehydraulicuid.
•Usecardboardorpapertondhydraulic
leaks.
•Safelyrelieveallpressureinthehydraulic
systembeforeperforminganyworkonthe
hydraulicsystem.
•Makesurethatallhydraulic-oilhoses
andlinesareingoodcondition,andall
hydraulicconnectionsandttingsaretight
beforeapplyingpressuretothehydraulic
system.
55