Toro 74953 - Page 152

MOWER DECKS
6-15Toro Z Master G3 3000/5000/6000 Series Service Manual
6
13. Install bearing shield (Fig. 429).
Fig. 427 DSCN-2703a
12. Install the seal spacer on the top of the spindle
housing (Fig. 428).
Fig. 428 DSCN-2704a
Fig. 429 DSCN-2705a
11. Lower the spindle housing over the spindle shaft
(Fig. 427).
14. Install the square key onto the spindle shaft.
15. Install the pulley hub on the spindle shaft (Fig. 430).
Fig. 430 DSCN-2707a