Toro 74953 - Right Park Brake Cable Removal (2011 & Prior)

CHASSIS
3-27Toro Z Master G3 3000/5000/6000 Series Service Manual
3
Right Park Brake Cable Removal (2011 &
Prior)
1. Raise the rear end of the unit and install jack stands
under the tie down loops on the frame. Remove the
RH and LH wheels from the unit (Fig. 098).
Fig. 098 PICT-8962
2. Disengage the park brake lever.
3. Remove the two nuts located on the end of the park
brake cable (Fig. 099).
Fig. 099 PICT-9075
Fig. 100 PICT-9083a
5. Slide the brake cable out of the cable anchor and out
towards the rear of the unit (Fig. 101).
Fig. 101 PICT-9084a
4. With needle nose pliers, squeeze the tabs on the
brake cable and pull brake cable out of the slot in the
cable anchor (Fig. 100).