Toro 74957 - Adjusting the Anti-Scalp Rollers

AdjustingtheHeight-of-CutPin
Theheightofcutisadjustedfrom25to140mm(1to
5-1/2inches)in6mm(1/4inch)incrementsbymovingthe
clevispinintodifferentholelocations.
1.Movethetransportlocktothelockposition.
2.Pushonthedeck-liftpedalwithyourfootandraisethe
mowerdecktothetransportposition(alsothe140mm
(5-1/2inch)cutting-heightposition);refertoFigure26.
3.Toadjust,rotatethepin90degreesandremovethepin
fromtheheight-of-cutbracket(Figure26).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheightofcutdesired,andinsertthepin(Figure
26).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
Figure26
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itisrecommended
toadjusttheheightoftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheneutral-lockedposition,
andsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
3.Adjusttheanti-scalprollersasshowninFigure27,
Figure28,andFigure29.
Figure27
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
Figure28
1.Anti-scalproller3.Flangenut
2.Bushing4.Bolt
Figure29
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
25