T o g o straight, mo v e both traction control lev ers
equally .
T o tur n, mo v e the lev er located on the side y ou
w ant to tur n bac k to w ard the neutral position
while k ee ping the other lev er eng ag ed.
T he far ther y ou mo v e the traction control lev ers
in either direction, the faster the traction unit will
mo v e in that direction.
T o slo w or stop , mo v e the traction control lev ers
to neutral.
Attachment Tilt Lever
T o tilt the attac hment forw ard, slo wly push the
attac hment tilt lev er forw ard.
T o tilt the attac hment rearw ard, slo wly pull the
attac hment tilt lev er rearw ard.
Loader Arm Lever
T o lo w er the loader ar ms , slo wly push the loader
ar m lev er forw ard.
T o raise the loader ar ms , slo wly pull the loader
ar m lev er rearw ard.
Auxiliary Hydraulics Lever
T o operate a h y draulic attac hment in forw ard
direction, slo wly pull the auxiliar y h y draulics lev er
upw ard and then rearw ard.
T o operate a h y draulic attac hment in rev erse
direction, slo wly pull the auxiliar y h y draulics lev er
upw ard and then push it forw ard. T his is also
called the detent position because it does not
require operator presence .
Speed Selector Lever
Mo v e the speed selector lev er to the forw ard
position to set the traction dri v e , loader ar ms , and
attac hment tilt to high speed and the auxiliar y
h y draulics to lo w speed.
Mo v e the speed selector lev er to the rearw ard
position to set the auxiliar y h y draulics to high
speed and the traction dri v e , loader ar ms , and
attac hment tilt to lo w speed.
If y ou mo v e the speed selector lev er while
the traction unit is in motion, the traction
unit will either stop suddenl y or accelerate
quickl y . If y ou operate the traction unit with
the speed selector lev er in an inter mediate
position, the traction unit will operate
er raticall y and may be dama ged. Y ou could
lose contr ol of the traction unit and injur e
bystander s or y our self.
• Do not mo v e the speed selector lev er
when the traction unit is in motion.
• Do not operate the traction unit when
the speed selector is in an y inter mediate
position (i.e., an y position other than
full y f orw ard or full y r earw ard).
Hour Meter
T he hour meter displa ys the n umber of hours of
operation that ha v e been log g ed on the traction
unit.
After 50 hours and then ev er y 100 hours thereafter
(that is at 150, 250, 350, etc .) the screen displa ys
CHG OIL to remind y ou to c hang e the oil. After
ev er y 100 hours , the screen displa ys SV C to
remind y ou to perfor m the other maintenance
procedures based on a 100, 200, or 400 hour
sc hedule . T hese reminders come on star ting three
hours prior to the ser vice inter v al time and flash
at regular inter v als for six hours .
14
To Next Page
Loading...
