Toro Dingo 322 - Transporting the Unit

25
Maintenance
Service Interval Chart
8 Hours 25 Hours 100 Hours 200 Hours 400 Hours Yearly/Storage
Grease the traction unit
Check engine oil level
g
Check for loose fasteners
Check tire pressure (20 psi)
Clean primary air filter
1
Check hydraulic oil level
y
Inspect hydraulic lines for leaks
Change engine oil
1, 2
Ch k btt l t lt l l
Check battery electrolyte level
Check wheel lug nut torque (50 ft
-
lbs)
3
Check
wheel
lug
nut
torque
(50
ft
-
lbs)
3
Check battery cable connections
Change engine oil filter (every other oil change)
1, 4
Check engine speed (1200 rpm idle and 3600 full throttle, ± 75)
g( )
Check spark plugs
Change hydraulic filter
1, 3, 5
gy
Inspect fuel lines for leaks
Change hydraulic oil
1, 6
Replace primary and secondary air filters
1
yy
Replace the fuel filter
1
T ouch up chipped paint
1. More often in dusty , dirty conditions.
2. Change oil after the first 50 operating hours.
3. Change the hydraulic filter and torque the lug nuts after the first 8–10 operating hours
4. For severe duty or rental applications, change every 100 operating hours.
5. For severe duty or rental applications, change every 200 operating hours.
6. For severe duty or rental applications, change every 400 operating hours