8. Press the next button. The next program
start time number will begin flashing.
9. To review or change another start time,
return to step 3.
10. Return the control dial to run .
To Change Zone Run Times:
1. Turn the control dial to the
set zone times position.
2. Set the
programs switch as needed to
select the desired program.
3. Zone number 1 will be flashing and its
current run time or OFF will be shown.
To select a different zone number, press
the +/
on or –/off button.
4. Press the next button.
5. To set the run time, press the +/on or
–/
off button.
Note: To remove a zone run time, select OFF
by pressing the +/on and –/off buttons at the
same
time.
6. Press the next button.
7. To review or change a run time for another
zone, repeat steps 5
and 6
.
8. Return the control dial to run .
To Turn the Timer Off:
When the control dial is turned to off, the
timer immediately shuts off any watering
operation currently in progress. Leaving the
control dial in the off position will prevent all
automatic and manual watering operations.
For extended shutdown of the sprinkler
system, leave the control dial in the
off
position.
Timer operation is resumed by turning the
control dial to
run .
12
To Next Page
Loading...
Need help?
General
