Adjustments
Throttle Control Adjustment (Fig. 1)
Before adjusting carburetor, make sure throttle control
is operating properly.
1. Loosen cable clamp screw securing cable to engine.
2. Move remote throttle control lever forward to FAST
position.
3. Pull firmly on throttle cable until back of swivel con-
tacts stop.
4. Tighten cable clamp screw.
Figure 1
1. Throttle casing clamp screw
2. Throttle cable
3. Swivel
4. Stop
5. Choke casing clamp screw
6. Choke cable
7. Choke butterfly
Choke Control Adjustment (Fig. 1)
1. Loosen cable clamp screw securing cable to engine.
2. Move remote choke control lever forward to CLOSED
position.
3. Pull firmly on choke cable until choke butterfly is
completely closed, then tighten cable clamp screw.
1
2
5
6
7
3
4
Adjustments Page 3 - 2 Greensmaster
®
3100
To Next Page
Loading...
