Toro Greensmaster eFlex 1018 - Maintenance; Accessing the Cutting Unit; Checking the Reel-Driveshaft Grease Point

Maintenance
AccessingtheCuttingUnit
Accessthebedknifeandreelformaintenanceas
follows:
•Withthecuttingunitremovedfromthemachine,
propuptherearofthecuttingunittoensurethat
thenutsonthebackendofthebedbaradjusting
screwsarenotrestingontheworksurface(Figure
4).
g311262
Figure4
1.Prop(notprovided)2.Bedknifeadjustingscrew
nut(2)
•Withthecuttingunitattachedtothemachine,lower
thetraction-unithandletotheground(Figure5).
g310731
Figure5
Checkingthe
Reel-DriveshaftGrease
Point
ServiceInterval:Yearly
1.Removethehardwarethatsecuresthereel-drive
assemblytothesideplate(Figure6).
g310788
Figure6
1.Socket-headscrew
2.Nut
2.Removethenutsfromtheinsideoftheside
plate(Figure6).
3.Checktheinsideofthereeldriveshaft(Figure7)
foranyremaininggrease.
Ifyoudonotseeasufcientamountofgrease,
addmoregreasetothemaleandfemalespline
shaft.
g310809
Figure7
1.Reeldriveshaft
4.Usethepreviouslyremovedsocket-headscrews
andnutstosecurethereel-driveassemblyto
thesideplate.
5.Installthecuttingunittothetractionunit;referto
yourtractionunitOperator’sManual.
6