Greensmaster 3300/3400Hydraulic System Page 5 -- 104
Steering Cylinder
1. Steering cylinder
2. Frame
3. Rear steering fork
4. Jam nut (4 used)
5. Rear wheel spindle
6. Steering spindle
7. Rear wheel and tire
8. Retaining ring (2 used)
9. Ball joint (2 used)
10. Cylinder spacer
Figure 75
FRONT
RIGHT
9
5
7
1
3
4
6
8
2
4
9
8
60 to 80 ft--lb
(82 to 108 N--m)
60 to 80 ft--lb
(82 to 108 N--m)
10
Removal (Fig. 75)
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components in
this section.
2. Operate all hydraulic controls to relieve hydraulic
system pressure.
3. Toalloweasieraccesstosteeringcylinder,raiseand
supporttankmountplateassembly(hydraulicreservoir,
fuel tank and tank mount plate) (see Tank Mount Plate
AssemblyintheServiceandRepairssectionofChapter
7 -- Chassis).
4. Labelsteeringcylinderhydraulichosesforassembly
purposes. Thoroughly clean hydraulic hose ends prior
to disconnecting the hoses from steering cylinder.
To Next Page
Loading...
