Greensmaster 3300/3400 GroomerPage 9 -- 11
5. Loosen cap screws (item 10) that secure front roller
shaft to groomer arms.
6. Remove lock nut (item 13) and spring washer (item
12)thatsecureRHgroomerarmliftrodtoRHdriveplate
assembly. Location of these items are shown in Figure
8.
7. Remove lock nut (item 21), special washer (item 16)
and plowbolt (item22) that secure RHgroomerarmas-
sembly to RH drive plate assembly. Do not change
height--of--cut screw adjustment. Remove RH g roomer
arm assembly from cutting unit.
8. Remove front roller assembly from cutting unit.
NOTE: To prevent grooming reel shaft from turning
when removing driven pulley (item 19), use wrench on
shaft flats to hold shaft.
9. Remove the lock nut (item 1) that secures driven
pulley (item 19) to grooming reel shaft. Remove driven
pulley from shaft.
NOTE: To prevent cutting reel from turning when re-
moving drive pulley (item 4), block reel with piece o f
wood.
10.Loosen and remove drive pulley (item 4) from the
cutting reel shaft.
11.Remove two (2) shoulder bolts (item 5) that secure
the RH drive plate assembly to the cutting unit frame.
Removethe groomerdrive plateassemblyfrom groom-
ing shaft and cutting unit. Locate and retrieve groomer
shim (item 8).
12.Carefully pull the grooming reel assembly from the
LH support plate.
13.Inspect seals, bushings and bearings in RH drive
plate, LH support plate and groomer arms for wear or
damage. Also, inspect pulleysandidler componentsfor
wear or damage. Replace components as needed.
Installation (Fig. 7)
1. Apply a light coating of grease to ends of grooming
shaft and also to seal lips in RH drive and LH support
plates. Make sure that all bearings, bushings and seals
are properly installed.
2. Make sure that O--ring (item 27) is installed on
grooming shaft. Apply light coating of grease to O--ring.
3. Carefully place grooming reel assembly into the LH
support plate taking care to not damage seal in support
plate or O--ring on shaft.
1. Roller cap screw
2. Grooming reel assembly
3. Lock nut
4. Spring washer
5. Groomer arm lift rod
Figure 8
4
2
1
3
5
1. Drive pulley
2. Idler pulley
3. Driven pulley
4. Drive plate assembly
5. Groomer drive belt
Figure 9
1
2
4
3
5
4. Apply light coating of grease to O--ring on RH drive
plate assembly pivot hub and pilot bore of cutting unit
side plate.
5. Positiongroomer shim(item8) todrive plateassem-
bly.
6. CarefullyplaceRHdriveplateassemblyontogroom-
er shaft taking care to not damage seals in drive plate.
Position drive plate to the cutting unit frame and secure
withtwo(2) shoulderbolts(item 5).Makesurethatdrive
plate rotates freely after installation.
7. Apply light coating of grease to hub on driven pulley
(item19)takingcaretonot getgreaseon beltsurfaceof
pulley. Slide driven pulley onto the grooming reel shaft
takingcaretonotdamagesealinsideplate.
NOTE: To prevent grooming reel shaft from turning
when installing driven pulley (item 19), use wrench on
shaft flats to hold shaft.
Groomer
To Next Page
Loading...
