Haul the Machine (continued)
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use only full-width ramps.
• Ensure that the length of ramp is at least 4 times as long as the height of the trailer
or truck bed to the ground. This ensures that ramp angle does not exceed 15
degrees on flat ground.
G229507
Full-width ramp(s) in stowed
position
Ramp is at least 4 times as long as
the height of the trailer or truck bed to
the ground
H = height of the trailer or truck bed
to the ground
Trailer
Loading the Machine
WARNING
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use extreme caution when operating a machine on a ramp.
• Load and unload the machine with the heavy end up the ramp.
• Avoid sudden acceleration or deceleration while driving the machine on a ramp as
this could cause a loss of control or a tip-over situation.
1. If using a trailer, connect it to the towing vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
Operation: After Operation Page 4–12 3451-705A
To Next Page
Loading...
