Toro Power Max 726 OE - Installing the Chute; Installing the Chute Control Rod

Note:Ifthetrunniondoesnottintothehole
whenyouliftuponthespeedcontrolrod,rotatethe
trunnionupwardordownwardonthespeedcontrol
roduntilitts.
7.Securethetrunnionandupperendofthespeedcontrol
rodwiththeouterwasherandahairpincotteryou
previouslyremoved.
Note:Foreasierinstallation,lookdownthroughthe
openinginthespeedselector(Figure7).
Figure7
1.Speedselector
3
InstallingtheChute
Partsneededforthisprocedure:
2Nut
2Bolt
Procedure
1.Placethechuteontheframeandthealignthedischarge
chutemounttothechutesupport.
g01901 1
1
2
Figure8
1.Bolt2.Nut
2.Securethedischargechutemountusing2boltsand
2nuts.
4
InstallingtheChuteControl
Rod
Partsneededforthisprocedure:
2
Carriagebolts
2Locknuts
Procedure
1.UnwraptheQuickStickandrotateitsothatitis
uprightandinthecenter.
2.Holdthebluetriggercapdownandpulltheleverfully
rearward.
Note:Thedischargechuteanddeectorshouldface
forward.Iftheydonot,holdthebluetriggercap
down(butdonotmovetheQuickStick)androtatethe
dischargechuteuntiltheydo.
3.Aligntheattenedbackendofthelongchutecontrol
rodwiththeattenedfrontendoftheshortrod
thatextendsfromthecontrolpanelsothattheynest
together(
Figure9).
9