Maintenance
30
Fuel
Filter
Service Interval/Specification
Replace the fuel filter after every 200 operating hours
or yearly, whichever occurs first.
Replacing the Fuel Filter
Never install a dirty filter if it is removed from the
fuel line.
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
2. Close fuel shut–off valve at fuel tank (Fig. 29).
3. Squeeze the ends of the hose clamps together
and slide them away from the filter (Fig. 30).
4. Remove the filter from the fuel lines.
5. Install a new filter and move the hose clamps
close to the filter.
6. Open fuel shut-off valve at fuel tank (Fig. 29).
1
2
3
m–2596
Figure 30
1. Hose
clamp
2.
Fuel line
3. Filter
Replacing
the Drive Belt
Service Interval/Specification
Check all belts after every 50 operating hours or
monthly, whichever occurs first. Look for dirt, wear,
cracks and signs of overheating.
1. Remove top capscrew securing idler support and
idler bracket to rear frame (Fig. 31).
2. Loosen bottom two mounting screws enough to
allow belt to pass between drive pulley and idler
support (Fig. 31).
3.
Raise wheel of
f ground enough to allow belt
removal.
2
m–1722
1
4
3
Figure 31
1. Top
capscrew
2.
Idler bracket
3.
Idler support
4.
Bottom capscrew
To Next Page
Loading...
